D62179 introduced a regression. llvm-readelf lose the ability to dump the dynamic symbols
when there is .dynamic section with a DT_SYMTAB, but there are no program headers:
https://reviews.llvm.org/D62179#1652778
Below is a program flow before the D62179 change:
1) Find SHT_DYNSYM.
2) Find there is no PT_DYNAMIC => don't try to parse it.
3) Print dynamic symbols using information about them found on step (1).
And after the change it became:
1) Find SHT_DYNSYM.
2) Find there is no PT_DYNAMIC => find SHT_DYNAMIC.
3) Parse dynamic table, but fail to handle the DT_SYMTAB because of the absence of the PT_LOAD. Report the "Virtual address is not in any segment" error.
This patch fixes the issue. For doing this it checks that the value of DT_SYMTAB was
mapped to a segment. If not - it ignores it.
Differential revision: https://reviews.llvm.org/D67078
llvm-svn: 371071
We use both -long-option and --long-option in tests. Switch to --long-option for consistency.
In the "llvm-readelf" mode, -long-option is discouraged as it conflicts with grouped short options and it is not accepted by GNU readelf.
While updating the tests, change llvm-readobj -s to llvm-readobj -S to reduce confusion ("s" is --section-headers in llvm-readobj but --symbols in llvm-readelf).
llvm-svn: 359649
Summary:
This patch adds support for merged arguments (e.g. -SW == -S -W) for llvm-readelf.
No changes are intended for llvm-readobj. There are a few short flags (-sd, -sr, -st, -dt) that would conflict with grouped single letter flags, and having only some grouped flags might be confusing. So, allow merged flags for readelf compatibility, but force separate args for llvm-readobj. From what I can tell, these two-letter flags are only used with llvm-readobj, not llvm-readelf.
This fixes PR40064.
Reviewers: jhenderson, kristina, echristo, phosek
Reviewed By: jhenderson
Subscribers: llvm-commits
Differential Revision: https://reviews.llvm.org/D56629
llvm-svn: 351205
George Rimar