with SUBREG_TO_REG, teach SimpleRegisterCoalescing to coalesce
SUBREG_TO_REG instructions (which are similar to INSERT_SUBREG
instructions), and teach the DAGCombiner to take advantage of this on
targets which support it. This eliminates many redundant
zero-extension operations on x86-64.
This adds a new TargetLowering hook, isZExtFree. It's similar to
isTruncateFree, except it only applies to actual definitions, and not
no-op truncates which may not zero the high bits.
Also, this adds a new optimization to SimplifyDemandedBits: transform
operations like x+y into (zext (add (trunc x), (trunc y))) on targets
where all the casts are no-ops. In contexts where the high part of the
add is explicitly masked off, this allows the mask operation to be
eliminated. Fix the DAGCombiner to avoid undoing these transformations
to eliminate casts on targets where the casts are no-ops.
Also, this adds a new two-address lowering heuristic. Since
two-address lowering runs before coalescing, it helps to be able to
look through copies when deciding whether commuting and/or
three-address conversion are profitable.
Also, fix a bug in LiveInterval::MergeInClobberRanges. It didn't handle
the case that a clobber range extended both before and beyond an
existing live range. In that case, multiple live ranges need to be
added. This was exposed by the new subreg coalescing code.
Remove 2008-05-06-SpillerBug.ll. It was bugpoint-reduced, and the
spiller behavior it was looking for no longer occurrs with the new
instruction selection.
llvm-svn: 68576
1. Use the same value# to represent unknown values being merged into sub-registers.
2. When coalescer commute an instruction and the destination is a physical register, update its sub-registers by merging in the extended ranges.
llvm-svn: 66610
Right now if the coalesced copy def is dead and its src is a kill, and that
there are now other uses within the live range, the coalescer would mark the
def of the source register as dead. But it should also check if there are
other kills which means the value has other uses not in the live range.
llvm-svn: 64075
v1024 = EDI // not killed
=
= EDI
One possible solution is for the coalescer to examine the sub-register live intervals in the same manner as the physical register. Another possibility is to examine defs and uses (when needed) of sub-registers. Both solutions are too expensive. For now, look for "short virtual intervals" and scan instructions to look for conflict instead.
This is a small win on x86-64. e.g. It shaves 403.gcc by ~80 instructions.
llvm-svn: 61847
172 %ECX<def> = MOV32rr %reg1039<kill>
180 INLINEASM <es:subl $5,$1
sbbl $3,$0>, 10, %EAX<def>, 14, %ECX<earlyclobber,def>, 9, %EAX<kill>,
36, <fi#0>, 1, %reg0, 0, 9, %ECX<kill>, 36, <fi#1>, 1, %reg0, 0
188 %EAX<def> = MOV32rr %EAX<kill>
196 %ECX<def> = MOV32rr %ECX<kill>
204 %ECX<def> = MOV32rr %ECX<kill>
212 %EAX<def> = MOV32rr %EAX<kill>
220 %EAX<def> = MOV32rr %EAX
228 %reg1039<def> = MOV32rr %ECX<kill>
The early clobber operand ties ECX input to the ECX def.
The live interval of ECX is represented as this:
%reg20,inf = [46,47:1)[174,230:0) 0@174-(230) 1@46-(47)
The right way to represent this is something like
%reg20,inf = [46,47:2)[174,182:1)[181:230:0) 0@174-(182) 1@181-230 @2@46-(47)
Of course that won't work since that means overlapping live ranges defined by two val#.
The workaround for now is to add a bit to val# which says the val# is redefined by a early clobber def somewhere. This prevents the move at 228 from being optimized away by SimpleRegisterCoalescing::AdjustCopiesBackFrom.
llvm-svn: 61259
the copy instruction from the instruction list before asking the
target to create the new instruction. This gets the old instruction
out of the way so that it doesn't interfere with the target's
rematerialization code. In the case of x86, this helps it find
more cases where EFLAGS is not live.
Also, in the X86InstrInfo.cpp, teach isSafeToClobberEFLAGS to check
to see if it reached the end of the block after scanning each
instruction, instead of just before. This lets it notice when the
end of the block is only two instructions away, without doing any
additional scanning.
These changes allow rematerialization to clobber EFLAGS in more
cases, for example using xor instead of mov to set the return value
to zero in the included testcase.
llvm-svn: 57872
"If a re-materializable instruction has a register
operand, the spiller will change the register operand's
spill weight to HUGE_VAL to avoid it being spilled.
However, if the operand is already in the queue ready
to be spilled, avoid re-materializing it".
llvm-svn: 56837
RA problem by expanding the live interval of an
earlyclobber def back one slot. Remove
overlap-earlyclobber throughout. Remove
earlyclobber bits and their handling from
live internals.
llvm-svn: 56539
isImmediate(), isRegister(), and friends, to avoid confusion
about having two different names with the same meaning. I'm
not attached to the longer names, and would be ok with
changing to the shorter names if others prefer it.
llvm-svn: 56189
vr2 = OR vr0, vr1
=>
vr2 = OR vr1, vr1 // after coalescing vr0 with vr1
Update the value# of the destination register with the copy instruction if that happens.
llvm-svn: 56165
vr1024 = extract_subreg vr1025, 1
...
vr1024 = mov8rr AH
If vr1024 is coalesced with AH, the extract_subreg is now illegal since AH does not have a super-reg whose sub-register 1 is AH.
llvm-svn: 56118
Evan Cheng