value is zero.
This allows optmizations to kick in more easily.
Fix some test cases so that they remain meaningful (i.e., not completely dead
coded) when optimizations apply.
<rdar://problem/14096009> superfluous multiply by high part of zero-extended
value.
llvm-svn: 184222
The main advantages here are way better heuristics, taking into account not
just loop depth but also __builtin_expect and other static heuristics and will
eventually learn how to use profile info. Most of the work in this patch is
pushing the MachineBlockFrequencyInfo analysis into the right places.
This is good for a 5% speedup on zlib's deflate (x86_64), there were some very
unfortunate spilling decisions in its hottest loop in longest_match(). Other
benchmarks I tried were mostly neutral.
This changes register allocation in subtle ways, update the tests for it.
2012-02-20-MachineCPBug.ll was deleted as it's very fragile and the instruction
it looked for was gone already (but the FileCheck pattern picked up unrelated
stuff).
llvm-svn: 184105
Rather than using the full power of target-specific addressing modes in
DBG_VALUEs with Frame Indicies, simply use Frame Index + Offset. This
reduces the complexity of debug info handling down to two
representations of values (reg+offset and frame index+offset) rather
than three or four.
Ideally we could ensure that frame indicies had been eliminated by the
time we reached an assembly or dwarf generation, but I haven't spent the
time to figure out where the FIs are leaking through into that & whether
there's a good place to convert them. Some FI+offset=>reg+offset
conversion is done (see PrologEpilogInserter, for example) which is
necessary for some SelectionDAG assumptions about registers, I believe,
but it might be possible to make this a more thorough conversion &
ensure there are no remaining FIs no matter how instruction selection
is performed.
llvm-svn: 184066
Replace the ill-defined MinLatency and ILPWindow properties with
with straightforward buffer sizes:
MCSchedMode::MicroOpBufferSize
MCProcResourceDesc::BufferSize
These can be used to more precisely model instruction execution if desired.
Disabled some misched tests temporarily. They'll be reenabled in a few commits.
llvm-svn: 184032
Also add a seperate vector lit test file, since r600 doesn't seem to handle
v2i32 load/store yet, but we can test both for SI.
Patch by: Aaron Watry
Reviewed-by: Tom Stellard <thomas.stellard@amd.com>
Signed-off-by: Aaron Watry <awatry@gmail.com>
llvm-svn: 184021
We were using RAT_INST_STORE_RAW, which seemed to work, but the docs
say this instruction doesn't exist for Cayman, so it's probably safer
to use a documented instruction instead.
Reviewed-by: Vincent Lejeune<vljn at ovi.com>
llvm-svn: 184015
When we're rematerializing into a not-quite-right register we already add the
real definition as an imp-def, but we should also be marking the "official"
register as dead, since nothing else is going to use it as a result of this
remat.
Not doing this can affect pressure tracking.
rdar://problem/14158833
llvm-svn: 184002
in functions which call __builtin_unwind_init()
__builtin_unwind_init() is an undocumented gcc intrinsic which has this effect,
and is used in libgcc_eh.
Goes part of the way toward fixing PR8541.
llvm-svn: 183984
This is a resubmit of r182877, which was reverted because it broken
MCJIT tests on ARM. The patch leaves MCJIT on ARM as it was before: only
enabled for iOS. I've CC'ed people from the original review and revert.
FastISel was only enabled for iOS ARM and Thumb2, this patch enables it
for ARM (not Thumb2) on Linux and NaCl, but not MCJIT.
Thumb2 support needs a bit more work, mainly around register class
restrictions.
The patch punts to SelectionDAG when doing TLS relocation on non-Darwin
targets. I will fix this and other FastISel-to-SelectionDAG failures in
a separate patch.
The patch also forces FastISel to retain frame pointers: iOS always
keeps them for backtracking (so emitted code won't change because of
this), but Linux was getting much worse code that was incorrect when
using big frames (such as test-suite's lencod). I'll also fix this in a
later patch, it will probably require a peephole so that FastISel
doesn't rematerialize frame pointers back-to-back.
The test changes are straightforward, similar to:
http://lists.cs.uiuc.edu/pipermail/llvm-commits/Week-of-Mon-20130513/174279.html
They also add a vararg test that got dropped in that change.
I ran all of lnt test-suite on A15 hardware with --optimize-option=-O0
and all the tests pass. All the tests also pass on x86 make check-all. I
also re-ran the check-all tests that failed on ARM, and they all seem to
pass.
llvm-svn: 183966
This is a preliminary patch for fast instruction selection on
PowerPC. Code generation can differ between DAG isel and fast isel.
Existing tests that specify -O0 were written to expect DAG isel. Make
this explicit by adding -fast-isel=false to the tests.
In some cases specifying -fast-isel=false produces different code even
when there isn't a fast instruction selector specified. This is
because TM.Options.EnableFastISel = 1 at -O0 whether or not a FastISel
object exists. Thus disabling fast isel can actually produce less
conservative code. Because of this, some of the expected code
generation in the -O0 tests needs to be adjusted.
In particular, handling of function arguments is less conservative
with -fast-isel=false (see isOnlyUsedInEntryBlock() in
SelectionDAGBuilder.cpp). This results in fewer stack accesses and,
in some cases, reduced stack size as uselessly loaded values are no
longer stored back to spill locations in the stack.
No functional change with this patch; test case adjustments only.
llvm-svn: 183939
The pass emits a call to sqrt that has attribute "read-none". This call will be
converted to an ISD::FSQRT node during DAG construction, which will turn into
a mips native sqrt instruction.
llvm-svn: 183802
Previously LEA64_32r went through virtually the entire backend thinking it was
using 32-bit registers until its blissful illusions were cruelly snatched away
by MCInstLower and 64-bit equivalents were substituted at the last minute.
This patch makes it behave normally, and take 64-bit registers as sources all
the way through. Previous uses (for 32-bit arithmetic) are accommodated via
SUBREG_TO_REG instructions which make the types and classes agree properly.
llvm-svn: 183693
the Mips16 port. A few of the psuedos could either take signed
or unsigned arguments and I did not distinguish the case and improperly
rejected some valid cases that the assembler had previously accepted
when they were pure pseudos that expanded as assembly instructions.
llvm-svn: 183633
Since we have ARM unwind directive parser and assembler, we
can check the correctness in two stages:
1. From LLVM assembly (.ll) to ARM assembly (.s)
2. From ARM assembly (.s) to ELF object file (.o)
We already have several "*.s to *.o" test cases. This CL adds
some "*.ll to *.s" test cases and removes the redundant "*.ll to *.o"
test cases.
New test cases to check "*.ll to *.s" code generator:
- ehabi.ll: Check the correctness of the generated unwind directives.
- section-name.ll: Check the section name of functions.
Removed test cases:
- ehabi-mc-cantunwind.ll
(Covered by ehabi-cantunwind.ll, and eh-directive-cantunwind.s)
- ehabi-mc-compact-pr0.ll
(Covered by ehabi.ll, eh-compact-pr0.s, eh-directive-save.s, and
eh-directive-setfp.s)
- ehabi-mc-compact-pr1.ll
(Covered by ehabi.ll, eh-compact-pr1.s, eh-directive-save.s, and
eh-directive-setfp.s)
- ehabi-mc.ll
(Covered by ehabi.ll, and eh-directive-integrated-test.s)
- ehabi-mc-section-group.ll
(Covered by section-name.ll, and eh-directive-section-comdat.s)
- ehabi-mc-section.ll
(Covered by section-name.ll, and eh-directive-section.s)
- ehabi-mc-sh_link.ll
(Covered by eh-directive-text-section.s, and eh-directive-section.s)
llvm-svn: 183628
Changes to ARM unwind opcode assembler:
* Fix multiple .save or .vsave directives. Besides, the
order is preserved now.
* For the directives which will generate multiple opcodes,
such as ".save {r0-r11}", the order of the unwind opcode
is fixed now, i.e. the registers with less encoding value
are popped first.
* Fix the $sp offset calculation. Now, we can use the
.setfp, .pad, .save, and .vsave directives at any order.
Changes to test cases:
* Add test cases to check the order of multiple opcodes
for the .save directive.
* Fix the incorrect $sp offset in the test case. The
stack pointer offset specified in the test case was
incorrect. (Changed test cases: ehabi-mc-section.ll and
ehabi-mc.ll)
* The opcode to restore $sp are slightly reordered. The
behavior are not changed, and the new output is same
as the output of GNU as. (Changed test cases:
eh-directive-pad.s and eh-directive-setfp.s)
llvm-svn: 183627
instantiation issue with non-standard type.
Add a backend option to warn on a given stack size limit.
Option: -mllvm -warn-stack-size=<limit>
Output (if limit is exceeded):
warning: Stack size limit exceeded (<actual size>) in <functionName>.
The longer term plan is to hook that to a clang warning.
PR:4072
<rdar://problem/13987214>.
llvm-svn: 183595
On PPC32, [su]div,rem on i64 types are transformed into runtime library
function calls. As a result, they are not allowed in counter-based loops (the
counter-loops verification pass caught this error; this change fixes PR16169).
llvm-svn: 183581
We weren't computing structure size correctly and we were relying on
the original alloca instruction to compute the offset, which isn't
always reliable.
Reviewed-by: Vincent Lejeune <vljn@ovi.com>
llvm-svn: 183568
Option: -mllvm -warn-stack-size=<limit>
Output (if limit is exceeded):
warning: Stack size limit exceeded (<actual size>) in <functionName>.
The longer term plan is to hook that to a clang warning.
PR:4072
<rdar://problem/13987214>
llvm-svn: 183552
My recent ARM FastISel patch exposed this bug:
http://llvm.org/bugs/show_bug.cgi?id=16178
The root cause is that it can't select integer sext/zext pre-ARMv6 and
asserts out.
The current integer sext/zext code doesn't handle other cases gracefully
either, so this patch makes it handle all sext and zext from i1/i8/i16
to i8/i16/i32, with and without ARMv6, both in Thumb and ARM mode. This
should fix the bug as well as make FastISel faster because it bails to
SelectionDAG less often. See fastisel-ext.patch for this.
fastisel-ext-tests.patch changes current tests to always use reg-imm AND
for 8-bit zext instead of UXTB. This simplifies code since it is
supported on ARMv4t and later, and at least on A15 both should perform
exactly the same (both have exec 1 uop 1, type I).
2013-05-31-char-shift-crash.ll is a bitcode version of the above bug
16178 repro.
fast-isel-ext.ll tests all sext/zext combinations that ARM FastISel
should now handle.
Note that my ARM FastISel enabling patch was reverted due to a separate
failure when dealing with MCJIT, I'll fix this second failure and then
turn FastISel on again for non-iOS ARM targets.
I've tested "make check-all" on my x86 box, and "lnt test-suite" on A15
hardware.
llvm-svn: 183551
Fix an assertion when the compiler encounters big constants whose bit width is
not a multiple of 64-bits.
Although clang would never generate something like this, the backend should be
able to handle any legal IR.
<rdar://problem/13363576>
llvm-svn: 183544
OpenBSD's stack smashing protection differs slightly from other
platforms:
1. The smash handler function is "__stack_smash_handler(const char
*funcname)" instead of "__stack_chk_fail(void)".
2. There's a hidden "long __guard_local" object that gets linked
into each executable and DSO.
Patch by Matthew Dempsky.
llvm-svn: 183533
Add earlyclobber constaints to prevent input register being allocated as
the output register because, according to Intel spec [1], "If any pair
of the index, mask, or destination registers are the same, this
instruction results a UD fault."
---
[1] http://software.intel.com/sites/default/files/319433-014.pdf
llvm-svn: 183327
Quentin Colombet