with SUBREG_TO_REG, teach SimpleRegisterCoalescing to coalesce
SUBREG_TO_REG instructions (which are similar to INSERT_SUBREG
instructions), and teach the DAGCombiner to take advantage of this on
targets which support it. This eliminates many redundant
zero-extension operations on x86-64.
This adds a new TargetLowering hook, isZExtFree. It's similar to
isTruncateFree, except it only applies to actual definitions, and not
no-op truncates which may not zero the high bits.
Also, this adds a new optimization to SimplifyDemandedBits: transform
operations like x+y into (zext (add (trunc x), (trunc y))) on targets
where all the casts are no-ops. In contexts where the high part of the
add is explicitly masked off, this allows the mask operation to be
eliminated. Fix the DAGCombiner to avoid undoing these transformations
to eliminate casts on targets where the casts are no-ops.
Also, this adds a new two-address lowering heuristic. Since
two-address lowering runs before coalescing, it helps to be able to
look through copies when deciding whether commuting and/or
three-address conversion are profitable.
Also, fix a bug in LiveInterval::MergeInClobberRanges. It didn't handle
the case that a clobber range extended both before and beyond an
existing live range. In that case, multiple live ranges need to be
added. This was exposed by the new subreg coalescing code.
Remove 2008-05-06-SpillerBug.ll. It was bugpoint-reduced, and the
spiller behavior it was looking for no longer occurrs with the new
instruction selection.
llvm-svn: 68576
entered via fall-through. Don't miss fallthroughs from blocks
terminated by conditional branches. Also, move
isOnlyReachableByFallthrough out of line.
llvm-svn: 68129
e.g.
%reg1024<def> = MOV r1
%reg1025<def> = ADD %reg1024, %reg1026
r0 = MOV %reg1025
If it's not possible / profitable to commute ADD, then turning ADD into a LEA saves a copy.
llvm-svn: 68065
x * 40
=>
shlq $3, %rdi
leaq (%rdi,%rdi,4), %rax
This has the added benefit of allowing more multiply to be folded into addressing mode. e.g.
a * 24 + b
=>
leaq (%rdi,%rdi,2), %rax
leaq (%rsi,%rax,8), %rax
llvm-svn: 67917
stoppoint nodes around until Legalize; doing this
imposed an ordering on a sequence of loads that
came from different lines, interfering with scheduling.
llvm-svn: 67692
help out the register pressure reduction heuristics in the case of
nodes with multiple uses. Currently this uses very conservative
heuristics, so it doesn't have a broad impact, but in cases where it
does help it can make a big difference.
llvm-svn: 67586
e.g. allocating for GR32, bh is not used, updating bl spill weight.
bl should get the same spill weight otherwise it will be choosen
as a spill candidate since spilling bh doesn't make ebx available.
This fix PR2866.
llvm-svn: 67574
same as a normal i80 {low64, high16} rather
than its own {high64, low16}. A depressing number
of places know about this; I think I got them all.
Bitcode readers and writers convert back to the old
form to avoid breaking compatibility.
llvm-svn: 67562
a data dependency on the load node, so it really needs a
data-dependence edge to the load node, even if the load previously
existed.
And add a few comments.
llvm-svn: 67554
Duncan Sands