Remove AstJumpLabel
AstJumpGo now references one if its enclosing AstJumpBlocks, and
branches straight after the referenced block.
That is:
```
JumpBlock a {
...
JumpGo(a);
...
}
// <--- the JumpGo(a) goes here
```
This is sufficient for all use cases and makes control flow much easier to
reason about. As a result, V3Const can optimize a bit more aggressively.
Second half of, and fixes#6216
Added test for a particularly convoluted case requiring fixup in
V3Premit. To help with statistics stability, also prevent V3Premit from
introducing temporaries for assignment where the RHS reads the LHS, but
the assignment is known to be atomic (by emitted C++ semantics).
Also rename `createWideTemp` to `createTemp`, as it is used for non-wide
expressions as well.
Previously DFG was limited to having a Sel, or an ArraySel potentially
under a Concat on the LHS of combinational assignments. Other forms or
combinations were not representable in the graph.
This adds support for arbitrary combinations of the above by
combining DfgSplicePacked and DfgSpliceArray vertices introduced in
#6176. In particular, Sel(ArraySel(VarRef,_),_) enables a lot more code
to be represented in DFG.
This is mostly a refactoring, but also enables handling some more
UNOPTFLAT, when the variable is only partially assigned in the cycle.
Previously the way partial assignments to variables were handled were
through the DfgVerexVar types themselves, which kept track of all
drivers. This has been replaced by DfgVertexSplice (which always drives
a DfgVeretexVar), and all DfgVertexVar now only have a single source,
either a DfgVertexSplice, if partially assigned, or an arbitrary
DfgVertex when updated as a whole.
Added a second algorithm to break cycles in DFG by identifying which
bits of a circular variable are actually independent of the variable,
then reuse the existing (but extended) driver tracing algorithm to
eliminate them.
This can fix up things like: `assign gray = binary ^ (gray >> 1)`
Wilson Snyder